So it goes like this. New show, new look, action - HC.Deselect(1)
Then if i run the script it takes fixture 1 out of the selection, no problems there.
example - 1/5* (selects 1 thru 5)
run script - deselects fixture 1.
Now the problem comes when i assign a value
run script - it deselects all fixtures.
I've noticed the same error with the selection filters
example 1/10@50* S12(select) S7(randomize) will also deselect all fixtures
whereas 1/10* S12 S7 works fine.
Open Source software contributions and discussions that supplement or extend the Palette / Light Palette software
1 post • Page 1 of 1