Fan with palettes 10.8.3

Is this a feature? Is this a bug? Give us feedback to make it better!
Post Reply
User avatar
Posts: 1186
Joined: Tue Oct 23, 2007 5:15 pm
Location: Cleveland, OH

Fan with palettes 10.8.3

Post by TaineGilliam » Tue Apr 12, 2011 11:42 pm

When I use the fan tool on a selection of fixtures set to a Palette the tool fails. If I set the fixtures to the same position using hard values the tool works as expected.

For example, create a position palette and point the four fixtures are the same spot on stage(choose a spot so the pan values for the fixtures are each different). Now select the fixtures and choose Fan Center. Roll the pan encoder. The fixtures move to the lowest pan value then begin to fan center. If you "twiddle" the pan encoder before activating the Tool all is ok.

Post Reply