movers taking short cut
-
- Posts: 5
- Joined: Thu Aug 05, 2010 3:14 pm
- Primary Venue / Use: University
- Where I Am: Hamilton,Ontario,Canada
movers taking short cut
2 movers in this cue. Mover 1 is given a path to follow over a cue time. Mover 2 is given a mirrored path in the same cue. At GO mover 1 takes the path while mover2 takes the shortest route to end position. What cueing error is being made?
Re: movers taking short cut
It sounds like one fixture is set to polar movement and the other fixture is set to linear movement. This is setup in position of the fixtures S5, S1 P/T mode. Check to see if they are both set the same.
- RobertBell
- Posts: 2421
- Joined: Fri Oct 12, 2007 1:11 pm
- Primary Venue / Use: Other
- Where I Am: Horizon Control Inc
- Location: On the dark side just north of Toronto
- Contact:
Re: movers taking short cut
also - make sure you know about flip
http://www.horizoncontrol.com/mqhelp/mq ... p/flip.htm
http://www.horizoncontrol.com/mqhelp/mq ... p/flip.htm
Robert Bell - Product Manager - Horizon Control Inc.