If you use the following syntax:
It is expected that channels 1 through 6 end up at zero. In reality only channel one goes to zero.
Independent times work as expected.
Is this a feature? Is this a bug? Give us feedback to make it better!
2 posts • Page 1 of 1
- Posts: 2421
- Joined: Fri Oct 12, 2007 1:11 pm
- Primary Venue / Use: Other
- Where I Am: Horizon Control Inc
- Location: On the dark side just north of Toronto
Works here. I'm using ENTER syntax in Hardware Setup | Console
Robert Bell - Product Manager - Horizon Control Inc.