Submaster operation with Intensity Wheel
-
- Posts: 23
- Joined: Thu Aug 03, 2017 10:10 am
- Primary Venue / Use: Professional Theatre
- Where I Am: Canton, Ohio
Submaster operation with Intensity Wheel
I have an annoying issue -- I have a submaster up at 80%. I select a channel controlled by the sub and adjust the level to 10% with the wheel. I clear the selection or adjust another channel. Then at a later time, I adjust the submaster to 60%. If I select the same channel again and try to adjust it, the intensity bumps to the new level of the submaster. The level always bumps to the sub level regardless of which way I turn the wheel, up or down. Then the wheel will adjust the level as it should. The actual levels do not matter. It happens at all levels EXCEPT if I adjust the submaster to "0" after selecting the single channel and adjusting it, the channel will not bump but will adjust normally. I hope you can follow this. Any ideas?? I remember a similar problem with the submaster fader wing when switching between pages. (This has been fixed). Could it be related??
- BobbyHarrell
- Posts: 2606
- Joined: Fri Oct 12, 2007 10:51 am
- Location: Livingston, NJ
- Contact:
Re: Submaster operation with Intensity Wheel
It took me a moment but I see the problem.
I'll send to the developer.
I'll send to the developer.
Bobby Harrell - Product Specialist
Philips Entertainment - Strand Lighting
Philips Entertainment - Strand Lighting
- msearancke
- Posts: 86
- Joined: Thu Jan 30, 2014 4:13 pm
- Primary Venue / Use: Professional Theatre
- Where I Am: Auckland, New Zealand
Re: Submaster operation with Intensity Wheel
I can see the problem you have described.
This issue will be fixed for the next release of the software.
Thanks,
Martin
This issue will be fixed for the next release of the software.
Thanks,
Martin
-
- Posts: 23
- Joined: Thu Aug 03, 2017 10:10 am
- Primary Venue / Use: Professional Theatre
- Where I Am: Canton, Ohio
Re: Submaster operation with Intensity Wheel
Super. Thank you.