Page 1 of 1

pan/tilt with track ball

Posted: Wed May 27, 2015 10:24 am
by GerMan
Hello, how can the track ball be used for the direct control by pan and tilt with movingheads?
With palette consoles this was possible and only the additional mouse steered the cursor.

thx, Maik

Re: pan/tilt with track ball

Posted: Wed May 27, 2015 11:05 am
by BobbyHarrell
You can press the CENTER key after the fixture is selected. The Center key will be Red and that's your indication that it's in P/T mode.

Note that the system is now in P/T mode and any touch to the touchscreen will move the selected fixture.