Page 1 of 1

Multi Use Channels

Posted: Wed Feb 12, 2014 1:13 pm
by NutsTM
Unpacked my 250ML today (much joy!) and I'm creating fixture profiles for my generic LED Pars. Their channel profile is DimmerRGB.

However, the dimmer channel is split into Dimmer (dmx 0-189) and Strobe (dmx 190-255). Is there currently a way to create this as I can't find it in any documentation.

Thanks,

Matt

Re: Multi Use Channels

Posted: Wed Feb 12, 2014 5:05 pm
by BobbyHarrell
Since these are both ranges of DMX, you might want to set this as the Dimmer or Intensity channel, then build a non-linear step so that when it hits 195, it says Strobe, then the rest (196-255) is variable. This can be done in the 250ML Fixture Library Creator software on the right hand side where you would create a non-linear channel map for the Intensity parameter.