Page 1 of 1

GO button with A/B faders.

Posted: Thu Nov 20, 2014 7:14 pm
by philpp
Hello
Test Software version 1.25B
GO button now works with A/B faders, It's indeed, But there are a problem
The faders always uses the time of memories, it's not good, because you cannot use faders in manual
when you move faders, the memory continuous to move up and down without taking into account the position of the faders
you must inhibit the time Up and Down when you move the faders in manual
(See manipulation as example with software Palette when you select "Cue list A/B Split crossfader" in Hardware Setup,it run very well )
I hope I was clear in my explanations
Thank for your answer

Re: GO button with A/B faders.

Posted: Tue Nov 25, 2014 1:08 pm
by BobbyHarrell
This has been reported to the software engineer.