Page 1 of 1

Channel selection

Posted: Thu Oct 02, 2014 8:13 am
by dkrause59
250ML Ver.12
On command line: press 1@10 ENTER, 2@20 ENTER, now channel 1 is adjusted and channel 2 is selected. Pressing SHIFT + ENTER selects both channels - not only the selected one as it would be logically and also written in manual. So generally i am unable to get selected channels only on encoder - all adjusted ones are also on encoder.

While channels on encoder: Pressing SHIFT + ENTER releases them and i get the former selection back on screen. That's OK, but it should also be possible for speeding up operation to terminate the encoder access by entering a new selection e.g. 3@30 ENTER. At the moment when entering a new selection, encoder access is canceled and the former selection is regained ignoring the new selection.