Page 1 of 1

Select a channel on the wheel without assigning a level

Posted: Wed Apr 29, 2015 3:49 am
by JCL
Hi,

As far as i understand there is no way to take the control of a channel with the wheel without specifying a level first, Am I wrong?
10 @ ENTER ENTER sets channel 10@ 0% then assigns it to the wheel
10 @ @ ENTER sets channel 10@ 100% then assigns it to the wheel...

what would be nice:
10 ENTER to select the channel (then you could either type "@XX ENTER" to specify a level or type "+15 ENTER" to add the channel 15 to the selection or press ENTER again see below)
10 ENTER ENTER to assign it to the wheel (would let you control the intensity without specifying a level first)

It doesn't look like extremely complex to implement, it's the way command line selection works in most console.
I hope you'll find this feature useful enough to add it, thanks.

Re: Select a channel on the wheel without assigning a level

Posted: Thu Apr 30, 2015 9:56 am
by BobbyHarrell
Good idea. Sent to the developer.