Page 1 of 1

labelling subs, cues, etc

Posted: Mon Sep 09, 2013 4:41 am
by HPCTechnical
No idea if this is possible, but would it be possible to allow a USB keyboard to be attached to the USB port in order to make labelling much quicker?

Re: labelling subs, cues, etc

Posted: Wed Sep 11, 2013 11:48 am
by BobbyHarrell
It has been discussed. Not sure if there is enough memory for the driver and such.

Re: labelling subs, cues, etc

Posted: Sun Sep 29, 2013 4:48 pm
by emiliocr
What if you create a off line editor that can be conected to the board? Then you could use the computer's keyboard. The smart fade by ETC uses that solution.

Re: labelling subs, cues, etc

Posted: Mon Sep 30, 2013 5:17 am
by BobbyHarrell
Currently, there is no Offline Editor for this board. However, there are many advantages to the SmartFade. 10 key. Command Line and a monitor just to name a few.

Re: labelling subs, cues, etc

Posted: Mon Sep 30, 2013 8:55 pm
by emiliocr
BobbyHarrell wrote:Currently, there is no Offline Editor for this board. However, there are many advantages to the SmartFade. 10 key. Command Line and a monitor just to name a few.
I believe the ML250 is a better board than the smart fade. I was suggesting a solution to the issue at hand.

Re: labelling subs, cues, etc

Posted: Tue Oct 01, 2013 6:56 am
by BobbyHarrell
ok. Thanks for the input.