clear fixture from display ?

Post Reply
Lighttech
Posts: 3
Joined: Sun Aug 24, 2014 12:31 pm
Primary Venue / Use: Regional Theatre
Where I Am: Aarhus,Denmark

clear fixture from display ?

Post by Lighttech » Sun Aug 24, 2014 12:48 pm

Is there anyway to loaded fixture from display ? without clearing the desk ?
Have some settings stored on faders. I want to keep this.

mpeters
Posts: 12
Joined: Wed Jan 06, 2010 5:48 pm
Primary Venue / Use: Other
Where I Am: Dallas, Tx

Re: clear fixture from display ?

Post by mpeters » Mon Aug 25, 2014 3:43 pm

To load a fixture into the 250ml you have to go into the Main Menu and then into the Patch screen. You will first have to assign a fixture to one of the softkey’s and then you will have to go into the DMX Patch and set its DMX address. If you check out page 15 thru 19 in the 250ml manual it will explain how to patch in a fixture profile. I have listed below a link to the manual. If you have any other questions let me know, thanks.

http://www.strandlighting.com/clientupl ... ay2014.pdf


Matthew Peters, Strand Tech Support Specialist
Matthew.peters@philips.com

Post Reply