Page 1 of 1

Cue percentages capture

Posted: Wed Jun 04, 2014 4:48 am
by nyltex
I'm trying to figure out if there is a way of capturing all the channels active on a cue?
This way it would be possible to adjust all the channels equally.
I can't find nothing relative to this on the manual.

Re: Cue percentages capture

Posted: Wed Jun 04, 2014 9:00 am
by BobbyHarrell
I've sent a request off to the programmer for two solutions here.

1. Pressing ENTER from a clean Command Line will capture all active channels.
2. CUE # ENTER will select all channels from the cue.