Intensity values in Position looks
Intensity values in Position looks
I ended up with intensity values in my positionlooks and they are applied to the channels too if I recall. I cannot get them out without making a new positionlook. I am pretty shure I never checked any checkbox to store anything else but positions and lense info.
- RobertBell
- Posts: 2421
- Joined: Fri Oct 12, 2007 1:11 pm
- Primary Venue / Use: Other
- Where I Am: Horizon Control Inc
- Location: On the dark side just north of Toronto
- Contact:
Re: Intensity values in Position looks
I just tried via the command line and notice in the STATUS area the text Position [PL]. That shows the default masking for that page. Do you see this. I definatly was left with deltas left on my intensities after recording a position (meaning they were not recorded).
Were you using the command line or DB?
Were you using the command line or DB?
Robert Bell - Product Manager - Horizon Control Inc.