Page 1 of 1

HC.Bump(...) can't unbump hardware-set toggle bumps

Posted: Tue Nov 15, 2011 1:08 am
by cpf
So I can go HC.Bump('Sub Page 1',12,1) to bump that look, then later HC.Bump('Sub Page 1',12,0) to unset it, but if I use the bump button to toggle it on, it's impossible to turn off with the script. It does, however, work the other way around (bumped on with the script, off with the button). Is this intentional? Is there any scriptable way to un-bump a look thats been bumped on with the physical button?

Re: HC.Bump(...) can't unbump hardware-set toggle bumps

Posted: Mon Nov 21, 2011 6:16 am
by MickCrozier
To beat this I put together the look effect assistant scripts
It's a bit of pain to setup - but by adding LookToggle() to a looks bump button and setting its action to action momentary - instead of bumping, it throws the look to 100% or 0%

Re: HC.Bump(...) can't unbump hardware-set toggle bumps

Posted: Mon Nov 21, 2011 10:13 am
by golights
I use the kill subs and kill all subs quite often. It would be nice to have them added permanently to the macro list.