Page 1 of 1

Fan with palettes 10.8.3

Posted: Tue Apr 12, 2011 11:42 pm
by TaineGilliam
When I use the fan tool on a selection of fixtures set to a Palette the tool fails. If I set the fixtures to the same position using hard values the tool works as expected.

For example, create a position palette and point the four fixtures are the same spot on stage(choose a spot so the pan values for the fixtures are each different). Now select the fixtures and choose Fan Center. Roll the pan encoder. The fixtures move to the lowest pan value then begin to fan center. If you "twiddle" the pan encoder before activating the Tool all is ok.