Page 1 of 1

10.8.1 Printing

Posted: Wed Sep 15, 2010 7:32 am
by gooze
First of all: great additions to printing. This is a very nice way to archive a show.

A few remarks.
- printing A4, portrait mode. The filename patch doesn't show completely. If it is too long for one line, it should go on to the next line.
Schermafbeelding 2010-09-15 om 13.20.30.png
Schermafbeelding 2010-09-15 om 13.20.30.png (19.97 KiB) Viewed 932 times
- In hardware setup it says 'Update when leaving Blind: NO" whereas my settings where "Immediate", also Level entry mode is set to "NO" instead of "Use [Enter] Key"
- Fixtures not used in cues could find it's place elsewhere in the software. Very nice. Bit complicated to do a printout just to check your unused fixtures :P
- It doesn't keep your settings, defaults to US letter and landscape. We are on A4 papersize. Could be automatically set if you choose for GeniusPro personality...
- Label in Cue list summary could be much longer. On of the main reasons to have a summary is to read to cuelabels. Landscape or portrait doesn't matter.

Re: 10.8.1 Printing

Posted: Wed Sep 15, 2010 9:19 am
by BrianEvans
There are NO printouts optimized for Portrait.
So much information.
Always use Landscape for best results.

Re: 10.8.1 Printing

Posted: Wed Sep 15, 2010 10:50 am
by gooze
Always remove options that don't work from software! ;)

Re: 10.8.1 Printing

Posted: Thu Sep 16, 2010 8:44 am
by BrianEvans
Preaching to the choir.
Blue Box In Patch.

Re: 10.8.1 Printing

Posted: Wed Oct 06, 2010 5:14 pm
by SimonWatson
RE 10.8.1 Printing
I have also noticed that not all the cues seem to print. I certainly missed some out of my printout that had B & C parts, these cues did not appear at all. Also the VariLite group position showed up as "PB X1 :16000" or some such huge number, and the printout showed a different gobo to the one shown on the desk.