Page 1 of 1

Playback Sliders Initialization Issue

Posted: Wed Jul 21, 2010 8:42 pm
by jmac
As requested, re-start of issue previously discussed in thread "Playback Slider Causes Dead Blackouts!". Bug tracker FS1668.

Log file (Test-1) for simple show has been sent to Horizon Control, as requested.

Summary of issue:

Playback sliders are set for left as PB Master, and right for XFader.

Start show file with both faders full up (or any position I think).

Using XF slider (before moving PBM slider) to advance thru Q-list causes the issue which is:

Tracked channels show up as blank (no intensity level indicated), and changed channels show up as red-box-zero (as if PBM was full down). All channels go to zero on stage.

Moving the PB master down and up a bit clears the issue.

The problem is basically if you don't move the PBM first, and use the XF (in lieu of Go button) to go to a next Q, you instead go immediately to a blackout condition, which can then only be cleared by moving the PBM down and back up.

This problem persists at least thru 10.6.6..

Re: Playback Sliders Initialization Issue

Posted: Tue Aug 31, 2010 10:02 pm
by jmac
Progress.....??

Re: Playback Sliders Initialization Issue

Posted: Tue Sep 07, 2010 10:13 am
by BobbyHarrell
back from vacation...will discuss.

Jim...please try it with 10.8.1.

Re: Playback Sliders Initialization Issue

Posted: Sun Sep 19, 2010 4:35 pm
by jmac
No change with 10.8.1. Problem still the same. I didn't see anything in the release notes mentioning that this issue was addressed, though it is a lengthy list, and I may not understand all the lingo.. Thanks.

Re: Playback Sliders Initialization Issue

Posted: Fri Oct 15, 2010 10:27 am
by jmac
This problem still not resolved.....

Re: Playback Sliders Initialization Issue

Posted: Wed Oct 20, 2010 6:32 pm
by Brennan
Sounds like 10.8.2 will be released soon (next week?). Hopefully they will have a chance to fix it in that software...