Multiple Cue Stacks As LTP

Is this a feature? Is this a bug? Give us feedback to make it better!
Post Reply
GeoffGooch
Posts: 25
Joined: Thu Dec 13, 2007 1:51 pm

Multiple Cue Stacks As LTP

Post by GeoffGooch » Fri Feb 05, 2010 5:18 pm

Can multiple cue stacks not work in LTP fashion? For example, I have six VL5's doing a curtain wash. In cuestack one they are blue in cuestack two they are red. I go Cuestack One and get blue lights. I go Cuestack Two then get red lights. If I go again on Cuestack Two I get no effect. Nothing changes until i release Cuestack Two. This is not how I expect multiple cue stacks to work. Please tell me if I am missing something obvious.

Thanks,
Geoff Gooch

User avatar
BrianEvans
Posts: 700
Joined: Fri Oct 12, 2007 1:11 pm
Location: Orlando, Florida

Re: Multiple Cue Stacks As LTP

Post by BrianEvans » Fri Feb 05, 2010 10:25 pm

The only thingS I can think of:
Check the priorities of the cue lists.
Be sure they have the same priority.

LTP does NOT see a change if values are tracked.

IE: cue 2 on a list is hard values, and cue 3 is all tracked values.
If you ran a cue 2, then ran a cue on a different stack, running cue 3 would not do anything.

I guess this behavior is debatable,
I know in my mind, it is correct.
If a cue doesn't have hard values for an attribute, it shouldn't do anything.
Otherwise, it'd be writing like block cues everywhere.
And you end up with a preset Desk.

If you do find more strange behavior, be sure to send us a show file.
support@horizoncontrol.com
Brian Evans - System Specialist - Horizon Control Inc.

Post Reply