Classic Palette.

User submitted ideas for how we can make the Palette and Light Palette Consoles better
Post Reply
User avatar
patf
Posts: 13
Joined: Thu Dec 13, 2007 11:03 am

Classic Palette.

Post by patf » Thu Feb 14, 2008 6:52 am

Classic Palette. Any joy on Effects on Looks and a Real Grand Master.
Pf.
SLC Dublin.

User avatar
RobertBell
Posts: 2421
Joined: Fri Oct 12, 2007 1:11 pm
Primary Venue / Use: Other
Where I Am: Horizon Control Inc
Location: On the dark side just north of Toronto
Contact:

Re: Classic Palette.

Post by RobertBell » Thu Feb 14, 2008 8:43 am

No movement on FX on Looks. Oh... how we want that priority to bubble to the top.
Also - there currently is no LOOK TYPE that behaves as a GM (as we can't do anything about adding an extra pot on the h/w, I figure this is what you're asking).
:added: FS468
Robert Bell - Product Manager - Horizon Control Inc.

User avatar
patf
Posts: 13
Joined: Thu Dec 13, 2007 11:03 am

Re: Classic Palette.

Post by patf » Thu Feb 14, 2008 9:25 am

Yes it is a Look type Gm as in the [Subs on a strand 300 ser desk.]
pf.

User avatar
golights
Posts: 159
Joined: Mon Feb 04, 2008 2:58 pm
Location: South Of Atlanta

Re: Classic Palette.

Post by golights » Tue Feb 26, 2008 6:03 pm

Would it be possible to add an adjustible fade time to the DBO buttons, like the cue list release time for the cue list releast button. This would not be the ideal solution but would give us some control over the blackout. 2 seconds would be better than a bump.

User avatar
RobertBell
Posts: 2421
Joined: Fri Oct 12, 2007 1:11 pm
Primary Venue / Use: Other
Where I Am: Horizon Control Inc
Location: On the dark side just north of Toronto
Contact:

Re: Classic Palette.

Post by RobertBell » Tue Feb 26, 2008 6:14 pm

Yes, that is in the plans.
Robert Bell - Product Manager - Horizon Control Inc.

User avatar
BrianEvans
Posts: 700
Joined: Fri Oct 12, 2007 1:11 pm
Location: Orlando, Florida

Re: Classic Palette.

Post by BrianEvans » Tue Feb 26, 2008 7:40 pm

I propose the following behavior on the Classic Palette.
(This was a brainstorm from LDI)

1. A hardware setup option under the Grand Master tab that allows the DBO buttons to individually be set to:
A. Momentary
B. Toggle
2. Each DBO button also has an individual:
A. Up Fade Time
B. Down Fade Time
3. DBO LED (Palette's only, not LightPalette)
A. OFF
B. LED Flashing - One or both GM's are fading (Unfortunately panel firmware may not even be capable of this?)
C. LED Solid - At least 1 GM enabled and finished fading out (static).
Brian Evans - System Specialist - Horizon Control Inc.

Post Reply