Page 1 of 1

calling and knocking out outputs

Posted: Fri Feb 15, 2008 6:22 pm
by mat
Can someone tell me if a syntax exists to do a (dimmer dimmer) like the 500 series?
I mean when i call several outputs and i want to release all of them , but i can't remember each output number .
I must forget something or doing something wrong,actually I go in patch , look at all outputs captured and release it one by one .
Does a release all outputs exists?

Re: calling and knocking out outputs

Posted: Fri Feb 15, 2008 6:44 pm
by PierTis
on LP V10.1. Genius 500.in Output
we release/Enter in same time to realese all output
but we have some problems to unpatch by output @ fixture(0), and need to Edit ligne for that
does we talk about same problems ?

Re: calling and knocking out outputs

Posted: Fri Feb 15, 2008 10:13 pm
by RobertBell
There was another post today regarding [Output] [Undo] [Undo] broke in v10.0.1. Gary is looking into this.

A work around would be [Output] [1] [Thru] [5000] [Undo] [Undo]

Re: calling and knocking out outputs

Posted: Sat Feb 16, 2008 6:56 am
by mat
that's why I didn't succeed
[Output] [Undo] [Undo] is a quite good syntax,short.