Page 1 of 1

Christie Digital

Posted: Wed Feb 13, 2008 9:24 am
by TerryHynes
We have a Christie Digital projector which has 10 attributes. How do I make this work on the Palette?

Re: Christie Digital

Posted: Wed Feb 13, 2008 9:43 am
by BrianEvans
I can build a library for it if you desire.

Just forward detailed DMX information to:
support@horizoncontrol.com

Best bet is the entire manual, this way if it has things like a zoom range, etc.,
It can be noted. DMX charts alone rarely have the information needed to build a library.

Re: Christie Digital

Posted: Wed Feb 13, 2008 10:33 am
by TerryHynes
Thanks, Brian. Tried to sent the manual as a PDF but it is over the size limit allowed. Is there some other way I can send it?

Re: Christie Digital

Posted: Wed Feb 13, 2008 10:50 am
by RobertBell

Re: Christie Digital

Posted: Wed Feb 13, 2008 10:57 am
by TerryHynes
Here is the DMX info as a Word Doc. Let me know if this works for you.
HD8K DMX.doc
(25.5 KiB) Downloaded 76 times

Re: Christie Digital

Posted: Wed Feb 13, 2008 11:49 am
by BrianEvans
Hey Terry,

That is pretty good.

A few questions.

1. Is the slider lock defaulted to "lock" or "unlock". (From what I read "unlock" is proabbly best,
that way the control power is accessible with no fuss.)
2. Lens Zoom range in degrees? (IE: 10 to 30 degrees, etc.)
3. Lens Pan and tilt range? (IE: + or - 10 degrees on pan and tilt (20 degrees total on each)

Any info would help.

Re: Christie Digital

Posted: Wed Feb 13, 2008 1:06 pm
by TerryHynes
Looks like "unlocked" should be the default. We have two zoom lenses 4.1-1 and 6.9-1. Pan & tilt offsets are +119%/-119% vertical and +42%/-42% horizontal.

NOTES: 1) 0% offset is equal to half the image above and below lens center OR half the image to the left or right of lens
center. 2) Offsets are subject to a ± 7% centering tolerance.

I hope this helps. Let me know. Thanks.

Re: Christie Digital

Posted: Thu Feb 14, 2008 8:36 pm
by BrianEvans

Re: Christie Digital

Posted: Fri Feb 15, 2008 3:07 pm
by TerryHynes
Thanks, Brian. I'll give it a try.