Page 1 of 1

palette vl fader help

Posted: Fri Apr 22, 2011 6:30 pm
by consolemonkey
I just went back to a palette vl with 64 faders. Recorded looks in subs played back fine. Ran a intensity chase (no movers in rig) came out of it and now all the subs on the right hand side of the console are disabled. They all work if you grab them virtually but only faders 17 - 24 & 41 - 48 work by grabbing the handle. I also work with an eos so I am not famliar with whether this is something I've done or a bug in the board or its updated software. Help!!! Tried reloading my new show an old show no effect in disgust I shut it down till tomarrow but cann't let it go.

Re: palette vl fader help

Posted: Fri Apr 22, 2011 9:28 pm
by golights
I would try openning the console and reseating the usb cables, then reboot the console. Sometimes just a reboot will reload the drivers.

Re: palette vl fader help

Posted: Mon Apr 25, 2011 12:57 pm
by BobbyHarrell
Yes. This is likely a tile issue and I would start by checking connections. You can see each tile in Help > Hardware Status and using the Hardware test from the Control Panel.

Re: palette vl fader help

Posted: Mon Apr 25, 2011 11:01 pm
by consolemonkey
Thank you both for the advice and rebooting the console worked this morning. I'm looking forward to working more with the console this summer.

Re: palette vl fader help

Posted: Tue Apr 26, 2011 8:33 am
by BobbyHarrell
ok. I'm glad it worked. Keep us informed and we want to help you as you move forward.