Page 1 of 1

Fixture check / Submaster Exclusif

Posted: Thu Mar 10, 2011 6:30 am
by PierTis
Hi,
i've a channel on Submaster Exclusif
-down=intensity at 0 in yellow

i check Fixtures on my show [Shift+Tool] {S2 Fixture check}
-on my Fixture (on Sub Exclusif) the check takes the level 80%

1/Is it normal?
2/Is it possible to make a choice on this level 80% ? (or is it like Hightlight?)
3/No Priority on this Sub Exclusif (even 1)is efficace . These fonctions work direct on output from board ?
Capture
If i've a curve On/Off on a Dimmer
- [S6 Output] Dimmer At 10% Enter pass direct in Output of the board
4/is there a possibility to pass Curve on priority upper Output?
Thanks

Re: Fixture check / Submaster Exclusif

Posted: Thu Mar 10, 2011 11:31 am
by RobertBell
1) :added: Bug 335 - Add Highlight (lowlight) into the editable Priority list (Make 35 by default)
2) no - fixed at 80%
3) What is correct? If you have an inverted profile (0 is FF in DMX), when you type [S6-Output] [x] [@] [y] [Enter] is the output of DMX y or 255-y? Currently it is y.
4) Is this the same question as 3)?

Re: Fixture check / Submaster Exclusif

Posted: Fri Mar 11, 2011 2:30 am
by PierTis
i need very often to put direct by curve On/Off : (scrollers, electrique-contact, Lampe Hmi..).
even i use ParkA,B,..
But nothing protect again Output At 30% on critique dimmer,
or Output check Forwad