Page 1 of 1

movers taking short cut

Posted: Thu Nov 11, 2010 3:36 pm
by Taras
2 movers in this cue. Mover 1 is given a path to follow over a cue time. Mover 2 is given a mirrored path in the same cue. At GO mover 1 takes the path while mover2 takes the shortest route to end position. What cueing error is being made?

Re: movers taking short cut

Posted: Thu Nov 11, 2010 4:44 pm
by golights
It sounds like one fixture is set to polar movement and the other fixture is set to linear movement. This is setup in position of the fixtures S5, S1 P/T mode. Check to see if they are both set the same.

Re: movers taking short cut

Posted: Tue Nov 16, 2010 11:45 am
by RobertBell
also - make sure you know about flip
http://www.horizoncontrol.com/mqhelp/mq ... p/flip.htm