Questions on Palette and Light Palette operation and features
Post Reply
User avatar
Posts: 115
Joined: Mon Jun 02, 2008 12:19 pm
Location: Charlotte, NC


Post by barbarab » Sat Oct 25, 2008 10:48 am

What would be the best way to preheat my conventional lights before channel check?
On the 300 series I could do { 1 thru 500 @ 10} and then use Next to step through bringing them to full.
On the classic palette if I use fixture check under tools it takes everything else to zero; so does (Shift+Highlight)+Next.
eta: I saw there was a preheat question posted by bazzer a while back but not sure if he was asking the same thing since I don't know what the 500 feature is... sorry if I'm duplicating.

User avatar
Posts: 700
Joined: Fri Oct 12, 2007 1:11 pm
Location: Orlando, Florida

Re: preheating

Post by BrianEvans » Sat Oct 25, 2008 11:17 am

Your syntax is actually very close.

Here is a way to make it work.

1/512@10 Enter
1 Enter
F8 (Hightlight)

Hope that helps!
Brian Evans - System Specialist - Horizon Control Inc.

Post Reply